Crown CMA-1 Manuel d'instructions télécharger pdf (Page 9)

5-CHANNEL WIRING

The amplifier inputs are white cables. Each cable is marked with a numbered band at the end of the

cable.

1. Refer to

Figure 5 for the following connections:

Connect CH 1 signal (left-front) to white input cable 1.

Connect CH2 signal (right-front) to white input cable 2.

Connect CH3 signal (left-rear) to white input cable 3.

Connect CH4 signal (right-rear) to white input cable 4.

Connect CH5 signal (Subwoofer) to whit input cable 5.

2. Set the amplifier switch to 5 CH as in

Figure 6. This provides the following output powers:

CH1: 50 W at 4 ohms

CH2: 50 W at 4 ohms

CH3: 50 W at 4 ohms

CH4: 50 W at 4 ohms

CH5: 100 W at 8 ohms

(These are minimum recommend loads.)

3. Refer to

Figure 5. Connect the speakers as follows. Route the CMA-1 colored output cables

separate from its white input cables to prevent oscillations. Using crimp terminals, connect the

CMA-1 colored cables to the speaker terminals, taking care to observe the cables colors and

polarities noted below:

Blk/Wht: CH 1 + Left-Front Speaker

Blk: CH 1 -

Wht/Red: CH 2 + Right-Front Speaker

Wht: CH 2 –

Red/Wht: CH 3 + Left-Rear Speaker

Red: CH 3 -

Grn/Yel: CH 4 + Right-Rear Speaker

Grn: CH 4 -

Blu/Red: CH 5 + Subwoofer

Yel/Red: CH 5 -

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Crown CMA-1 Manuel d'instructions Page 9