Crown Pulse 2650 Spécifications télécharger pdf (Page 4)

3. Names and Functions for UTG-2650

● Power on/Reset key ON/RST –to turn on or reset the tester. When the tester is turned on, LCD will display the

value of sound velocity used for the last measurement. The gauge will shut off automatically if idle for 4

minutes.

● Menu key MENU- to setup the tester .Press this key to move highlighted item to the following

menus-Save(N=1,2,3,4 or 5),Menu, EE, OFF.

● Enter key to accept the job selected by . If Off is highlighted by pressing MENU , hit to switch off

the gauge .Pressing MENU twice will send the gage back to main operation.

● Calibration key CAL – to calibrate the tester with built-in block on the unit.

● Operating key and

● Sound Velocity key VEL –to set the value of sound velocity to be used .Press to move on LCD toward

the digit to be changed and use operating key and to get the value.

5900

Up to five sound velocity values can be pre-stored by pressing VEL key when the value is set. Press VEL key

in sequence during the measurement will load the values saved in the tester .

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Crown Pulse 2650 Spécifications Page 4