Crown QMS Guide d'installation télécharger pdf (Page 15)

Network

Connection

QMS CrownNet Setup Guide

3 Attach another section of thin-wire Ethernet cable or a

50 ohm terminator to the other end of the BNC “T” connec-

tor.

4 Attach the BNC “T” connector to the BNC port on the Crown-

Net interface.

5 Plug in the printer, and turn it on.

6 Go to “Software Installation” on page 17.

Thick-Wire Ethernet Connection

Thick-wire Ethernet connections use AUI connectors.

1 Turn off the printer, and unplug the power cord.

2 Plug the transceiver through the retainer into the AUI port on

the CrownNet interface.

n If you’re using a transceiver with an integrated AUI cable,

tighten the retainer screws.

n If you’re using a transceiver without an AUI cable, attach the

AUI connector to the transceiver.

3 Plug in the printer, and turn it on.

4 Go to “Software Installation” on page 17.

Transceiver with an

integrated AUI connector

Transceiver with a

separate AUI

connector

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 85 86

Pas de commentaire

Crown QMS Guide d'installation Page 15