Crown SST-SBSC Spécifications télécharger pdf (Page 4)

Page 7

CE-Series

Amps with an Attitude!

Page 6

CE-Series

Amps with an Attitude!

Reference Manual

glow a bright green to indicate power is on.

8. (Now comes the fun!) Supply input, adjust amp levels and

enjoy.

9. You can check the green signal light to verify input, if nec-

essary.

CAUTION: Excessive output levels may toast your speak-

ers. Crown’s CE-Series amplifiers have such low distor-

tion, you may not realize the actual level being reached

until it’s too late. Please exercise caution and drive your

speakers responsibly (or at least warn your neighbors!).

Quick Start!

You’ve waited a long time for this! We know you just can’t wait

to crank up your new Crown

CE-Series

amplifier. And you

sure don’t want to flip through pages of tech-talk just to find out

where the on switch is. So that’s why we provided you with this

quick and simple page to get you up and running right away.

Just take a few minutes to read through this—no more than

five or ten, max—you’ll be glad you did.

1. Make sure the CE-Series

amp and all other equipment is

turned off (“O”) before you begin wiring. By the way, the

amp power switch is located on the far left side of the front

panel. It is off (“O”) when depressed on the left.

2. Mount your CE-Series amp securely in the rack, or posi-

tion it on a solid surface.

3. Connect the left and right inputs coming from your mixer,

preamp, or processor. You can use either balanced

/4-

inch (6.35-mm) phone, 3-pin XLR or barrier block con-

nectors. You can also choose to run in MONO mode. (See

Figure 2.5.)

4. Connect the output wiring (left and right speakers). You

will need two (2) Neutrik Speakon

NL4FC mating con-

nectors.

WARNING: Output terminals marked with the

symbol

are dangerous when live. External wiring connected to

these terminals requires installation by an instructed per-

son, or should make use of prebuilt wiring and connec-

tors.

5. Connect your CE-Series

amp and other equipment to the

appropriate power source.

6. Turn on your mixer, preamp, signal processor, or any other

equipment in your system EXCEPT your CE-Series amplifier.

(Remember: the best is worth waiting for.)

7. Make sure the Channel 1 and Channel 2 level (volume) con-

trols on your CE-Series amplifier are turned all the way down

(counterclockwise), then flip the power switch on (“I”). Note:

The Fault light blinks a few times, and the “Power” light will

Did You Remember To Get Your Speakons

Typical Stereo

Hookup

1 2 3 4 5 6 7 8 9 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Crown SST-SBSC Spécifications Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement musical supplémentaire Crown SST-SBSC