Crown CE-4000 Instructions d'exploitation télécharger pdf (Page 19)

Page 19

CE-Series

Amps with an Attitude!

2.6.4b—If the Mode switch is in the “Bridge” position (for

mono configuration), connect the load across the positive

(+) terminals of the connector as shown in Figure 2.8. Re-

fer to Figure 2.11 for complete system setup. For Bridge-

Mono Mode, non-inverting output, Ch1+ is the positive

(+) and Ch2+ is the negative (–).

2.6.4c—Never short or parallel the output channels of a

CE-Series

amplifier to itself or any other amplifier.

Fig. 2.8

Bridge-Mono

Output Wiring

2.6.5—Slide the connector insert (B) into the connector hous-

ing (A), making sure that the large notch on the outer

edge of the insert lines up with the large groove on the

inside of the connector housing. The insert should slide

easily through the housing and out the other side until it

extends approximately

/4-inch (19-mm) from the end of

the housing (see Figure 2.9).

Fig. 2.9

Detailed Neutrik

Speakon NL4FC

Connector

Assembly: Insert

into Connector

Housing

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Pas de commentaire

Crown CE-4000 Instructions d'exploitation Page 19